When you smell gas near your stove, water heater, or furnace in Mount Angel, you need immediate confirmation that the line is secure and the leak is stopped. Gas leaks do not wait for convenient appointment times, and improper repairs can create dangerous conditions that last for years. You need a plumber who can locate the source, repair or replace the damaged section, and test the entire system under pressure before turning the gas back on.
Pacific Pine Plumbing, LLC installs new gas lines, repairs leaking joints, and tests gas systems throughout Mount Angel. We run black iron pipe or CSST flexible lines to appliances, connect them with approved fittings, and pressure test every joint with a gauge to confirm zero loss over time. Whether you are adding a gas range, relocating a dryer, or upgrading to a tankless water heater, we size the line correctly and ensure it meets Oregon fuel gas code.
If you need gas line work in Mount Angel, contact Pacific Pine Plumbing, LLC to schedule an inspection or installation.
Gas line service in Mount Angel begins with shutting off the gas supply at the meter or appliance shutoff valve. We locate the leak using a combustible gas detector or soap solution, then cut out the damaged section and install a new length of pipe with threaded or brazed connections. Every joint gets tightened to the correct torque, and we apply pipe thread sealant rated for natural gas or propane before assembly.
After the repair or installation, you will notice that the gas odor disappears completely, appliances ignite without hesitation, and flames burn blue without soot or flickering. The system holds pressure without any measurable drop on the test gauge, which confirms that all connections are airtight. You can use your appliances without worrying about slow leaks or incomplete combustion that wastes fuel and creates carbon monoxide.
We install gas lines for ranges, cooktops, wall ovens, dryers, water heaters, furnaces, and fireplaces. If you are converting an appliance from electric to gas, we verify that your existing gas meter has enough capacity and install a dedicated line with the correct diameter for the appliance BTU rating. We do not splice old lines with compression fittings or run undersized pipe that causes low pressure at the burner.
Homeowners in Mount Angel often ask about leak detection methods, permit requirements, and when to replace old gas lines before scheduling service.
- How do you test for gas leaks?
- We use a combustible gas detector to scan connections and pipe runs, then apply soap solution to suspected areas and watch for bubbles. For whole-system testing, we pressurize the line with air or nitrogen and monitor a gauge for pressure drop over fifteen minutes.
- What permits are required for gas line work?
- Any new gas line installation, extension, or appliance connection requires a fuel gas permit and inspection. Pacific Pine Plumbing, LLC pulls permits, installs the line to code, and schedules the inspection before you use the appliance.
- When should old gas lines be replaced?
- If your gas lines are original to a home built before 1980, they may be uncoated steel that has corroded internally. Visible rust, flaking threads, or a sulfur smell near joints indicates it is time to replace sections or run new lines in Mount Angel homes.
- Why does my gas stove flame burn yellow or orange?
- A yellow or orange flame usually means incomplete combustion caused by a clogged burner orifice or insufficient gas pressure. If cleaning the burner does not fix it, the gas line may be undersized or partially blocked, and you should have Pacific Pine Plumbing, LLC check the supply pressure.
- What is the difference between black iron pipe and CSST?
- Black iron pipe is rigid steel threaded together at joints and used for main gas lines and exposed runs. CSST is corrugated stainless steel tubing that flexes and installs faster in tight spaces, but it requires grounding and special fittings approved for gas use.
Pacific Pine Plumbing, LLC installs and repairs gas lines throughout Mount Angel with proper sizing, approved materials, and pressure testing that confirms every connection is secure. Whether you need a leak repaired immediately or a new line run for a kitchen remodel, we handle the work safely and schedule the required inspection. Get in touch to schedule your gas line service.